Identifying a Quality Boat


HULL: Welding the entire hull as one unit, eliminates the undesirable feature of rivets below the water line. And we’ve been welding boats for 35 years! Our unique welding system reduces distortion and residual stresses which continue to perplex other welded boat manufacturers. The unitized hull of the Gregor is shaped for a smooth, dry ride with exceptional stability either at anchor or under way.	BOTTOM DESIGN: A well designed bottom which is carefully produced will yield superb performance and efficiency. By virtue of specific shape of the bottom, Gregor boat achieves maximum efficiency and performance without resorting to large horsepower required.	BOW: A smooth, dry, efficient ride requires a properly designed bow. With its clipper bow and wide flaring sides up forward, where it’s most needed, Gregor boats shed water out and away – away from passengers and gear. The sharp bow design attacks the water with les impact and spray.

TRANSOM: A properly designed transom contributes to performance and stability. The deep, wide and properly shaped transom of the Gregor boat gives maximum displacement where it is needed most. However, wider is not necessarily better. The proper width coupled with a superior shape is the key to stability and safety without sacrificing performance.	KEEL: Gregor incorporates into the bottom an integral center keel – a keel one piece with the bottom: the HYDROFLOW KEEL. This hydrodynamic low drag design prevents air from being carried into the propeller for smoother flow through the water, while at the same time contributing to the superb tracking ability of the Gregor.	SPLASH RAIL: The splash rail works in combination with hull shape to help keep passengers and gear dry. Do all boats have them? No! Not necessarily! On a Gregor the splash rail is an integral part of the hull, designed and engineered for maximum deflection of water and spray to keep you and you gear dry, even in rough water.

CHINE, GUN’LE & BOW STEM: These areas of the boat must take abuse, wear and tear and at the same time provide the hull with rigidity. At Gregor we utilize extrusions to achieve this end. Not all extrusions are the same. Our extrusions are of our exclusive design and specifications.	INTEGRATED STRUCTURAL SYSTEM: The structural system should be just that – a system – a fully engineered system – not a series of add-ons or heavier something-or-others.	SAFETY: For your safety, Gregor designers and engineers personally test each new model. Gregor’s standards for safety are among the highest in the industry. We endeavor to provide you with a boat you can enjoy – a safe and reliable boat – a Gregor Boat.